http://www.openzwave.com/device-database/010F:1000:0204
images/fibaro/fgs224.png
https://products.z-wavealliance.org/products/3980/
To remove the device from the Z-Wave network:
1. Power the device.
2. Set the main controller into remove mode (see the controller’s
manual).
3. Quickly, three times click the maintenance button.
4. LED will start blinking yellow, wait for the removing process to
end.
5. Successful removing will be confirmed by the Z-Wave controller’s
message and red LED colour.
The remotely operated FIBARO Double Smart Module is designed to turn electrical devices or circuits on and off. Double Smart Module allows to control two devices or circuits. The compact size of the device allows for the product to be installed in the housings of other devices. The devices can be controlled either via the Z-Wave™ network or with buttons connected directly to them.
https://Products.Z-WaveAlliance.org/ProductManual/File?folder=&filename=Manuals/3980/FGS-2x4-T-EN-1.0.pdf
To add the device to the Z-Wave network manually:
1. Power the device.
2. Set the main controller in (Security/non-Security Mode) add mode
(see the controller’s manual).
3. Quickly, three times click button connected to S1/S2 or the
maintenance button.
4. LED will start blinking yellow, wait for the adding process to end.
5. If you are adding in Security S2 Authenticated, input the underlined
part of the DSK (label on the bottom of the box).
6. Adding result will be confirmed by the Z-Wave controller’s message
and the LED:
• Green – successful (non-secure, S0, S2 non-authenticated),
• Magenta – successful (Security S2 Authenticated),
• Red – not successful.
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device:
1. Press and hold the maintenance button to enter the menu.
2. Release button when the device glows yellow.
3. Quickly click the button to confirm.
4. After few seconds the device will be restarted, which is signalled
with red LED colour.
Use reset procedure only if the primary controller is missing or inoperable.
FGS-224
FIBARO Double Smart Module
CEPT (Europe)
The FIBARO Double Smart Module is powered with the mains voltage so it is always awake.
Initial Metadata Import from Z-Wave Alliance Database - https://products.z-wavealliance.org/Products/3980/XML
This parameter determines the state of relays power supply failure (e.g. power outage). auto OFF and flashing modes the parameter not relevant and the relay will always remain off.