Smart Meter module responds to commands ALL ON / ALL OFF that may be sent by the main controller or by other controller belonging to the system If Smart plug 16A is ON, you can schedule it to turn OFF automatically after a period of time defined in this parameter. The timer is reset to zero each time the device receives an ON command, either remotely (from the gateway (hub) or associated device) or locally from the switch. 0 => Auto OFF disabled. 1 - 32535 => 1 second (0,01s) - 32535 seconds (325,35s). Auto OFF enabled with define time, step is 1s or 10ms according to parameter 15. Default value 0 If Smart plug 16A is OFF, you can schedule it to turn ON automatically after a period of time defined in this parameter. The timer is reset to zero each time the device receives an OFF command, either remotely (from the gateway (hub) or associated device) or locally from the switch. 0 - Auto OFF disabled. 1 - 32535 => 1 second (0,01s) - 32535 seconds (325,35s). Auto ON enabled with define time, step is 1s or 10ms according to parameter 15. Default value 0 Choose if you want to set the timer in seconds or milliseconds in parameters 11 and 12. This parameter determines if on/off status is saved and restored for the Smart plug 16A after power failure. Choose by how much power consumption needs to increase or decrease to be reported. Values correspond to percentages so if 20 is set (by default), the device will report any power consumption changes of 20% or more compared to the last reading. Set value from 0 - 100 (0% - 100%). 0 - Reporting Disabled. 1 - 100 = 1% - 100% Reporting enabled. Power report is send (push) only when actual power in Watts in real time change for more than set percentage comparing to previous actual power in Watts, step is 1%. Default value 20. Set value refers to the time interval with which power consumption in Watts is reported (0 - 32535 seconds). If 300 is entered (by default), energy consumption reports will be sent to the gateway (hub) every 300 seconds (or 5 minutes). Set value means time interval (0 - 32767) in seconds, when power report is send. 0 - Reporting Disabled. 1 second to 32767 seconds reporting enabled. Power report is send with time interval set by entered value. Default value 300 (power report in Watts is send each 300s). Lower power threshold used in param 52. Can not be higher than param 51 0-4000 (0.0 to 4000.0W, 0 disables) Upper power threshold used in param 52. Can not be higher than param 50 0-4000 (0.0 to 4000.0W, 0 disables) Parameter defines the way 3rd association group devices are controlled, depending on the current power load. The function allows for turning off the controlled device in case of exceeding the defined power for more than 3.1s. Controlled device can be turned back on by S-button or sending a control frame. By default this function is inactive. 1-4000 (1-4000W) 0 disables Using this parameter it is possible to enable/disable reporting after the set command (i.e. Basic set).