This parameter allows to set in what state is door/window when the magnet is close to the sensor. This parameter defines events indicated by the visual LED indicator. Disabling events might extend battery life. 0 - no indications 1 - indication of opening/closing status change (input IN) 2 - indication of wake up (1 x click or periodical) 4 - indication of device tampering This parameter defines how commands are sent in specified association groups: as secure or non-secure. Parameter is active only in Z-Wave network security mode. It does not apply to 1st group Lifeline Parameter defines events which result in sending on/off commands to devices added to the 2nd association group. These commands are sent alternately to switch the devices on and off. Value sent to devices in 2nd association group when opening is detected. The value of 0 turns OFF the device, 255 turns it On. In case of associating devices allowing smooth control, values 1-99 allow to set an associated device to a specified level. Value sent to devices in 2nd association group when closing is detected. The value of 0 turns OFF the device, 255 turns it On. In case of associating devices allowing smooth control, values 1-99 allow to set an associated device to a specified level. Time that must elapse from opening to send the command frame to to devices in 2nd association group. Time that must elapse from closing to send the command frame to devices in 2nd association group. Time period after which a tamper alarm will be cancelled. Reporting cancellation of tamper alarm to the controller and 3rd association group. This parameter defines how often the temperature will be measured. The shorter the time, the more frequently the temperature will be measured, but the battery life will shorten. 0 - temperature measurements disabled 5-32400 - time in seconds This parameter defines the change of temperature in comparison with last reported, resulting in temperature report being sent to the main controller. 0 - temperature reports based on threshold disabled 1-300 - temperature threshold (0.1-30C, 0.1C step) This parameter determines how often the temperature reports will be sent to the main controller. 0 - periodic temperature reports disabled 5-32400 - time in seconds The value to be added to the actual temperature, measured by the sensor (temperature compensation). (0.1C steps) Temperature alarms reported to the Z-Wave controller. Thresholds are set in parameters 55 and 56. If temperature is higher than set value, overheat notification will be sent and high temperature scene will be triggered (if activated). 0-600 (0-60C, 0.1C step). If temperature is lower than the set value, underheat notification will be sent and low temperature scene will be triggered (if activated). 0-599 (0-59.9C, 0.1C step)