salut je veux envoyer des sms à travers un dongle e3372h en utilisant smstools le problème j’arrive pas pour cause mon e3372h n’est pas connu en tant que modem voilà :
[ 2535.751968] usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 2535.751971] usb 1-1: Product: HUAWEI_MOBILE
[ 2535.751973] usb 1-1: Manufacturer: HUAWEI_MOBILE
[ 2535.751975] usb 1-1: SerialNumber: 0123486789ABGHTI
[ 2535.812920] usb-storage 1-1:1.0: USB Mass Storage device detected
[ 2535.834005] scsi host33: usb-storage 1-1:1.0
[ 2537.082735] usb 1-1: USB disconnect, device number 7
[ 2541.759913] usb 1-2: new high-speed USB device number 8 using ehci-pci
[ 2553.178960] usb 1-2: device not accepting address 8, error -110
[ 2553.811145] usb 1-2: new high-speed USB device number 9 using ehci-pci
[ 2554.141695] usb 1-2: New USB device found, idVendor=12d1, idProduct=14dc, bcdDevice= 1.02
[ 2554.141712] usb 1-2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 2554.141718] usb 1-2: Product: HUAWEI_MOBILE
[ 2554.141722] usb 1-2: Manufacturer: HUAWEI_MOBILE
[ 2554.376173] rndis_host 1-2:1.0 eth0: register 'rndis_host' at usb-0000:02:03.0-2, RNDIS device, 0c:8b:8f:27:9a:69
[ 2554.387798] usb-storage 1-2:1.2: USB Mass Storage device detected
[ 2554.438813] scsi host33: usb-storage 1-2:1.2
[ 2554.591334] rndis_host 1-2:1.0 enx0c8b8f279a69: renamed from eth0
[ 2555.478035] scsi 33:0:0:0: Direct-Access HUAWEI TF CARD Storage 2.31 PQ: 0 ANSI: 2
[ 2555.514189] sd 33:0:0:0: Attached scsi generic sg3 type 0
[ 2555.522663] sd 33:0:0:0: Power-on or device reset occurred
[ 2555.528519] sd 33:0:0:0: [sdb] Media removed, stopped polling
[ 2555.538745] sd 33:0:0:0: [sdb] Attached SCSI removable disk
lsusb
lsusb
Bus 001 Device 009: ID 12d1:14dc Huawei Technologies Co., Ltd. E33372 LTE/UMTS/GSM HiLink Modem/Networkcard
comment faire pour affecter un port ttyusb ou ttyacm ?
merci pour votre aide